Waking up in the morning and finding that your shower isn\u2019t sending any hot water your way is one of the more unpleasant surprises you can encounter. Any time that your home suddenly loses its supply of hot water is an emergency situation. What can you do about it? Below, we\u2019ll show you the best way to go about restoring your water heater to full function.<\/p>\n
If you have a standard storage tank water heater, it\u2019s possible that the supply of hot water has been drained from overuse. Give the water heater time to heat up more water. If nothing happens, it\u2019s time to seek elsewhere for the answer.<\/p>\n
Many water heaters have a thermostat or limit switch on them. If the thermostat is set incorrectly, the water heater may stop working.<\/p>\n
Older gas-powered water heaters usually rely on a pilot light to ignite their burners. If the pilot light goes out, the water heater won\u2019t work and you\u2019ll have to re-light the pilot. If you have a water heater that uses electronic ignition, it\u2019s possible that the igniter has failed, in which cases you\u2019ll need to have technicians replace it.<\/p>\n
The water heater may not be receiving gas because of a shut valve. Turn the gas knob back into place to open the line. However, don\u2019t tamper with the gas line any further than this!<\/p>\n
This applies to electronic water heaters. If the heating elements cause a circuit breaker to trip, there won\u2019t be any power to the system. Reset the breakers to see if this fixes the problem.<\/p>\n
If you can\u2019t find out the reason for the loss of hot water with the steps above, don\u2019t attempt any more fixes on your own. You need to have water heater repair professionals on the job. They\u2019ll track down the source of the water heater failure and repair it. If the problem can\u2019t be repaired, they\u2019ll arrange for the installation of a new water heater.<\/p>\n